Solar 4R Schools Activity Guide Teacher Manual L3: Grades 55 Photovoltaic Cell Experiments Lab Activity Step 1 – Photovoltaic Cell Performance Follow your teacher’s safety instructions and attach the red wire from the photovoltaic (PV) cell to the red lead of the multimeter (either clip or connect—if using quick disconnects. Close the white clip on the hydrogen hose and then reconnect the hose to the electrolyzer cell. Disconnect the battery and connect the solar panel. Shine the desk lamp directly on the solar cell to provide electricity to produce more hydrogen gas. Figure Hydrogen generation using “solar” energy. Sunlight hits the solar cell - if the energy of the photon is high enough Sciences-Modern Physics Virtual Lab-Solar Panel Experiment (Remote Trigger). very simple experiment that allows college students in introductory physics courses to plot the I-V characteristics of a solar cell, and hence measure important very simple experiment that.
The aim of this lab exercise is to experimentally create the Current vs. Voltage for an actual solar cell under various illumination conditions. Apparatus. 17 V (Nominal) Thin Film Amorphous Silicon Solar Module, Four W Halogen lamps, small electronic circuits to control load voltage of solar panel, standard Data Acquisition Equipment. Determination of solar cell characteristics. 3 GENERAL LAB INSTRUCTIONS 1. The students should attend the lab neatly with proper prescribed uniform. They should read the procedure thoroughly for the lab experiment from the manual and come well prepared. 5. They should bring the required things like scientific calculator, eraser, pencil, pen. elemental components using solar electricity and a fuel cell. They will also learn how the same fuel cell creates electricity by converting hydrogen and oxygen into water. Fuel Cell Lab Manual as the "Hydrogen" side, while the blue side is the "Oxygen" side. k. Place the gas tank assembly into the carrier on the.
cell solely depends upon its photovoltaic effect, hence a solar cell also known as photovoltaic cell. A solar cell is basically a semiconductor p-n junction device. It is formed by joining p-type (high concentration of hole or deficiency of electron) and n-type (high concentration of. This manual describes the photovoltaic performance model in the System Advisor Model (SAM). The U.S. Department of Energy’s National Renewable Energy Laboratory maintains and distributes SAM, which is available as a free download from www.doorway.ru These descriptions are based on SAM (SSC 41). Lab 8 – Heat, Solar Input and Earth’s available Energy: Lab 9 – Atomic Spectra and Solar Cells: refer to the appendices at the end of this lab manual.
0コメント