EVC EZ-II. INSTALLATION/SET-UP INSTRUCTIONS PART # BK v NOTICE Read this entire manual to understand how the EVC functions before beginning the installation process. Do not attempt to install or adjust the EVC without thorough knowledge of how this unit works. This manual assumes that you have the knowledge in the operation of tools and 5/5(2). HKS achieve the target boost setting. I C) Press the left side of the switch longer than a second to go to the Boost Control Mode For more accurate setting. Boost Mode Off Set Value ("OFS" appears on the monitor) Enter ing a larger number increases the boost pressure. Default Setting. 10% Adjust the setting between 0 I (t) Press the upper side of the switch to increase the . following: With "Low' and "Set" flashing, turn the EVC's volume knob counterclockwise until the display reads , then press "Sbc". Enter and press "Sbc" again. Drive the vehicle under full boost in third gear and read the boost pressure once it stabilizes. This figure is your stock boost. Reset the EVC unit (see directions on the next page).
A few notes before installing: If you have any other HKS EVC, or HKS EZ, you will have to use the stepping motor included with the EVC 6, all other versions of the stepping motor are incompatable with the EVC 6. - Just as was the case with the stepping motor, None of the wiring is the same for the EVC 6. You will need to completely remove. EVC EZ-II INSTALLATION/SET-UP INSTRUCTIONS PART # BK v The EVC cannot control boost pressure above the maximum efficiency point of the turbocharger. when adjusting the maximum boost pressure. Install an HKS iliary boost pressure meter to monitor manifold boost pressure levels. The utilization of an HKS A/F Knock Amp (air. HKS EVC EZ II The EVC EZ II is the most simplified version of HKS' electronic boost controllers, but still utilizes the same proven stepping motor as the EVC. With the same "state of the art" closed loop stepping motor, you are insured the same accurate and stable boost levels.
Directly input the desired boost value to modes A and B, and let the HKS EVC control the boost. Return Function The boost setting returns to the factory setting when the power is turned off. HKS achieve the target boost setting. I C) Press the left side of the switch longer than a second to go to the Boost Control Mode For more accurate setting. Boost Mode Off Set Value ("OFS" appears on the monitor) Enter ing a larger number increases the boost pressure. Default Setting. 10% Adjust the setting between 0 I (t) Press the upper side of the switch to increase the number and. The EVC is not capable of reaching boost levels lower than stock (OEM) levels. The EVC will maintain its programming even if the vehicle’s battery is disconnected or the head unit is unplugged. The serial numbers must match on the control unit and the stepping motor in order for the unit to function properly.
0コメント